|
|
#1
02-22-2007, 01:56 PM
|
||||
|
||||
Converting a Pure Engery HP tank to LP output
Hey guys I want to change my tank from HP to LP and I'm not sure if what I found is what I need. I found the PMI LP reactor but I'm not sure if this is what I need...http://www.skanline.com/pages-productinfo/category-2991_3011_3013/product-2442/paintball-tanks-nitro-tank-accessories-pure-energy-pure-energy-pmi-low-pressure-reactor.html?zenid=15d136f1d1d6c39fd7ed158a59a1565 0
Guidance from anybody in the know would be appreciated. Thanks.
__________________
Never go Bear hunting without a sandwich...sandwich: someone you can out run or don't mind shooting  Angel 1 Non-SOM Apr 07 Ripper 3 Non-SOM Apr 08 Family Photo My Feedback 
|
|
#2
02-22-2007, 02:35 PM
|
||||
|
||||
|
Re: Converting a Pure Engery HP tank to LP output
According to pmi's site that is the low pressure drop in kit.
doing it for the a1?
__________________
www.dliveleyphotography.com  Back to gun whoring..... armedfuture (8:12:32 PM): I'm a big angel paintball6684 (8:16:09 PM): more like out of control, raging ginger armedfuture (8:16:40 PM): noooooooo...........
|
|
#3
02-22-2007, 02:37 PM
|
||||
|
||||
|
Re: Converting a Pure Engery HP tank to LP output
Quote:
__________________
Never go Bear hunting without a sandwich...sandwich: someone you can out run or don't mind shooting Angel 1 Non-SOM Apr 07 Ripper 3 Non-SOM Apr 08 Family Photo My Feedback Last edited by MVS1 : 02-22-2007 at 03:09 PM.
|
|
#4
02-22-2007, 03:01 PM
|
||||
|
||||
|
Re: Converting a Pure Engery HP tank to LP output
Seems it would make more sense to contact PMI and ask them wouldn't it? Also seems you'd want a different burst disk(s) since the output will be lowered. I wouldn't even mess with it at all unless I had all of the specific info. Could result dangerous if you didn't -
__________________
 KUSA Old School Alumni #4939Registered: 6/26/02 Posts: 14,000+ before the old mothership went down Jealousy is the tribute mediocrity pays to genius while feeling alone apposed to smiling adversaries.... 
|
|
#5
02-22-2007, 03:09 PM
|
||||
|
||||
|
Re: Converting a Pure Engery HP tank to LP output
Good advice Drago, Their tech support is closed for tonight but I'll be giving them a call in the morning. From what I have gathered from online tech resources, Taco was spot on, it is designed as a drop in unit for the pure energy air systems, however I hadn't put any thought into the burst disc question. Thanks.
__________________
Never go Bear hunting without a sandwich...sandwich: someone you can out run or don't mind shooting Angel 1 Non-SOM Apr 07 Ripper 3 Non-SOM Apr 08 Family Photo My Feedback
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
