|
|
#1
01-30-2007, 03:40 PM
|
|||
|
|||
filling an HPA tank
is it possibe to fill it with an air compressor. liek the ones u use with like nail guns and stuff.thnx.
__________________
Spyder Electra 05' ACS Viewloader Evolution 3 w/ Z-Board "68ci 3000psi DYE Stickiez 3 blue 14" Redz pepper stick |
|
#2
01-30-2007, 04:13 PM
|
||||
|
||||
|
Re: filling an HPA tank
try it
|
|
#3
01-30-2007, 04:17 PM
|
||||
|
||||
|
Re: filling an HPA tank
Naw, yo wouldn't get nearly the same pressure that PB tanks get filled up to normally.
__________________
05 Imagine Palmer stabilizer Maddman Rocket valve Trinity Front block IPS Sunbear Bolt Dark Horizon titanium striker Green/silver VSC CCI Phantom Red/Black PMR SE |
|
#5
01-30-2007, 04:44 PM
|
||||
|
||||
|
Re: filling an HPA tank
If you have to ask the question, don't mess with compressed air unless you wouldn't mind possibly meeting your maker. I doubt you have a 3000+psi compressor anyways. That's what you would need -
__________________
 KUSA Old School Alumni #4939Registered: 6/26/02 Posts: 14,000+ before the old mothership went down Jealousy is the tribute mediocrity pays to genius while feeling alone apposed to smiling adversaries.... 
|
|
#6
01-30-2007, 04:48 PM
|
||||
|
||||
|
Re: filling an HPA tank
Quote:
__________________
 "If society is tranquil, it is not because it is conscious of its strength and its well-being, but because it fears its weakness and its infirmities; a single effort may cost it its life. Everyone feels the evil, but no one has courage or energy enough to seek the cure."
|
|
#7
01-30-2007, 05:22 PM
|
||||
|
||||
|
Re: filling an HPA tank
Air compressors that fill tires, run air tools and such produce no more than 150 psi..a Spyder runs at 800!! The size of the cylinder does not matter, it still will only fill your tank to 150psi.
Paintball cylinders are filled by special high pressure compressors that are much more expensive and far more dangerous to operate.
__________________
Angels, Timmys, ICD Bushy, Pimp, and lots of Spyders Old Farts Club
Member #12        "Your marker cannot harm me...I'm the Juggernaut!!" KUSA Feedback +56/-0 New PBN Feedback +20/-0 Old PBN Feedback +92/-0 |
|
#9
04-29-2007, 05:31 PM
|
|||
|
|||
|
Re: filling an HPA tank
no u need an air compresser that goes up to about 3000- 4500 psi and the ones that ur talkin about go up to maybe 200psi
__________________
the man |
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
