|
|
#11
01-01-2007, 03:12 PM
|
||||
|
||||
Re: Feedneck problem
Quote:
__________________
 KUSA Old School Alumni #4939Registered: 6/26/02 Posts: 14,000+ before the old mothership went down Jealousy is the tribute mediocrity pays to genius while feeling alone apposed to smiling adversaries.... 
|
|
#12
01-14-2007, 06:48 AM
|
||||
|
||||
|
Re: Feedneck problem
I wouldn't recommend taking the feedneck off to many times because when I had gone paintballing for my 3rd time with this gun, i had ended up stripping all of the threads and then it was so loose that my hopper just popped out and couldnt go back in...unless your suppose to clean the threads or something
|
|
#13
01-14-2007, 06:55 AM
|
||||
|
||||
|
Re: Feedneck problem
You prolly cross threaded it. The threads are very fine and you must be especially crareful turning it back on. Feeling the least bit of resistance(unless it's screwed all the way on) means that the threads aren't meshing correctly. Turn it any further at this point and you will cross thread it. I've never had this happen but heard people using JB Weld as a last resort. I have also heard of retapping the body as well -
__________________
KUSA Old School Alumni #4939Registered: 6/26/02 Posts: 14,000+ before the old mothership went down Jealousy is the tribute mediocrity pays to genius while feeling alone apposed to smiling adversaries....
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
