|
|
#1
10-09-2006, 11:59 AM
|
|||
|
|||
Java Feedneck ?
I got this feedneck for my pilot acs. The feedneck mounts to the gun nice and tight. Here is my question though the hopper doesn't quite fit snug enough to keep it from spinning. There is no way to tighten the top to make a better connection anyone else have experience or suggestions to remedy this.
Mark 
|
|
#2
10-09-2006, 12:07 PM
|
||||
|
||||
|
Re: Java Feedneck ?
Got a picture? Is it a clamping feedneck or one that uses o rings?
__________________
Angels, Timmys, ICD Bushy, Pimp, and lots of Spyders Old Farts Club
Member #12        "Your marker cannot harm me...I'm the Juggernaut!!" KUSA Feedback +56/-0 New PBN Feedback +20/-0 Old PBN Feedback +92/-0
|
|
#3
10-09-2006, 12:21 PM
|
|||
|
|||
|
Re: Java Feedneck ?
No it is not a clamping and I don not see any o rings on it.
http://www.pbreview.com/products/rev...od=2032&page=2 Mark
|
|
#4
10-09-2006, 12:50 PM
|
|||
|
|||
|
Re: Java Feedneck ?
I was checking out the reviews at pbreview.com and another user suggested to use a couple pieces of electrical tape to tighten the connection where I am having a porblem. I will try and see how that works. I would like to find something more permanent/ less ghetto to correct the problem.
Mark
|
|
#5
10-09-2006, 01:29 PM
|
||||
|
||||
|
Re: Java Feedneck ?
does it have a groove machined inside it? If not, tape is probably your only option....
__________________
Angels, Timmys, ICD Bushy, Pimp, and lots of Spyders Old Farts Club
Member #12 "Your marker cannot harm me...I'm the Juggernaut!!" KUSA Feedback +56/-0 New PBN Feedback +20/-0 Old PBN Feedback +92/-0
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
