E-99 avant redu

[yamaha cow]

i am redoing my whole e99 such as milling frame and body and stuff like that. I am thing of using bondo to remake my own body over the old stock one.

1: i am stripping my gripframe and milling then painting and putting on new grips.
2: i am bondoing my old stock e-99 body to make it look sick then painting it.
3: then i am getting a new reg and barrel.
4: new feed neck
5: new drop
6: new trigger


allready have new bolt.

and i need new gripframe electronics except the board for the esp 2.0 frame.
does any body know where i can get them.(all wires,the thing that trips the sear,microswitch,on off switch got shot and broke.

this should take all winter or hopefully it will.

[yamaha cow]

well it seems my board is fride as in dead i think the last time i plaeyd it got wet and went sizzling so i dont know what to do about that.

[bigred76]

Get a T-Board from Scenario Dreams and if you search their store you should be able to find spare parts for wiring, switches, capacitors, etc. Another place I'd go for a switch is X-Customs; the switch from them is $8 shipped and comes ready to just drop in without soldering.

[yamaha cow]

i think i found my board and wires on ebay tyhat i need. but thx dud i have someone tht i think i will recomend the x cutom site too.

[yamaha cow]

here are some pics of it so far





was

[ross * pilot]

what bolt did you get?

[yamaha cow]

kingman ACS bolt from my local pro shop.