i was thinking about this..

[bomberpilot07]

muahahah i got it working.... shooting at 350ish psi. havent chronoed it today but i will tomorrow... i got it to work, i replaced the noid and no jackhammers . im gonna get it chronoed tomorrow when i go to the feild

im def getting a vid of this hawt mofo

[adrianm1188]

Yup. Maddman doesnt hae good customer service.

I bought a rebuild kit from them recently, when it came The SRP was defective. The top part of the SRP had plastic over it.

Put it this way, the SRP allows the pin to grow through it right? Well the one he sent me had the material its made out of covering the top hole. (think of a soda bottle cap when screwing it on the bottle)


So yea, i told him, hasnt responded. Emailed him again, Hasnt responded. Im no pleased.


Dragon, Is this SRP a "new version" or is it just defective?

I had a thought that maybe he made it that way so the pin wouldnt push though the SRP and strip it. Whatya think?

[DRAGON]

Ya the SRP should be essentially like a plastic nut that's round on the outside. Threads on the inside to thread onto the valve shaft which should protrude all the way through. Have you tried just cutting the hole all the way through w/o cutting into the threads? Seen someone selling a repair kit in the b/s/t today for $10. There's pics there too -

I literally waited 4 months before they straightened my concern out. This only because I finally called the BBB & cops on them. Once they have your cash, they ignore you and customer service seem to be non-existent or they feed you a bunch of lies to buy time. This was my experience anyways -

[adrianm1188]

Yea, i dont see point in cutting it bcuz he would have done a ****ty job on threading the SRP if he couldnt have penetrated the bit through.

I just used my old valve pin on the rocket valve since it was already filed down and used the lil "defect" to my advantage.

...Still, i dont like recieving half-ass products when im paying 15$ for a pin, spring and a peice of plastic. =]

[bomberpilot07]

hehe 250 psi shooting 260fps today. ya thats hawt

[DRAGON]

Best to keep it around 300psi for efficiencies sake. What main spring?

[bomberpilot07]

heavy..

[bigred76]

Originally Posted by DRAGON

Best to keep it around 300psi for efficiencies sake.

I disagree, Drago....Long story short, PM me for why.

[DRAGON]

Try a lighter one if possible like medium or light. It will bring up the pressure a bit but yield less recoil and less chance of chops. Efficiency should be better as well. Lowest pressure is not the goal, remember? -

Originally Posted by bigred76

I disagree, Drago....Long story short, PM me for why.

You can share with all. We won't tell too many lol -

[bomberpilot07]

yes. i am going to have to turn up my pressure anyways in order to run nitro .