|
|
#3
02-21-2007, 04:22 PM
|
||||
|
||||
Re: Just a curious question..
Quote:
I know with the Trinity M16 mag will not fit without a lot of mods. You have to get the one made for the MR2. The port in to the gun is small, make most the ones out there useless since they have the bigger port. I have a Trinity M16 mag I need to sell becuase of this.
__________________
Sometimes you get the bear and sometimes you just gotta run!! Spyder MR2 J&J 14" Ceramic Barrel or Apex Barrel Halo B w/ Rip Drive & Victory Board Reflex Optic Sensor Sight Dye Sticky 3 Grips Trinity 6 Chamber Expansion Module Low Blow Bolt 
|
|
#4
02-21-2007, 07:09 PM
|
||||
|
||||
|
Re: Just a curious question..
I know about the Trinitys M-16 mag issue. I think im miss interpreting ur post Jarhead, but are u saying Trinity made a MR2 capadible M-16 mag? I know of the Ak-47 mag already though.
__________________
"Why so serious?"
|
|
#5
02-22-2007, 09:51 PM
|
||||
|
||||
|
Re: Just a curious question..
Personally, I would buy a used authentic M16 magazine, and customize it that way if your just going for the look. It will be hollow and you can easily hide a reg in there. Might need some scrap sheet metal you can pick up at home depot to dress up a receiver for it but it would be allot cheaper than buying a $65 expansion chamber......Could put the difference into buying a real regulator which would be more beneficial than an expansion chamber anyday.
Just my 2 cents
|
|
#6
02-23-2007, 06:20 AM
|
||||
|
||||
|
Re: Just a curious question..
If you bought a real mag, you'd have to get rid of the plastic forearm stock. You could easily rig something for the mag to attach to and drill a hole out the bottom or backside of the mag for the HP hose.
I buy used AR mags all the time for about $8 shipped. Or your local Army/Navy store may have some used ones too.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
