|
|
#1
12-31-2005, 09:51 AM
|
||||
|
||||
Need help now.
I got a new ShockTech trigger for Christmas and I'm putting it in and I don't know were the spring goes now. Can anyone help?
|
|
#2
12-31-2005, 09:53 AM
|
||||
|
||||
|
Re: Need help now.
Not having a pic to work with (and never having seen one in person), I'd wager a guess that it goes in the same spot as the stock one?
__________________
|
|
#3
12-31-2005, 09:57 AM
|
||||
|
||||
|
Re: Need help now.
I'll get a picture, one sec.
|
|
#4
12-31-2005, 10:00 AM
|
||||
|
||||
Re: Need help now.
 You put the spring in that hole on the bottom part shown there
|
|
#5
12-31-2005, 10:04 AM
|
||||
|
||||
|
Re: Need help now.
Am I suppose to take out the screw type thing that was in there?
|
|
#6
12-31-2005, 10:07 AM
|
||||
|
||||
|
Re: Need help now.
no....the screw adjusts your pre-travel. You adjust that screw to shift the trigger closer or farther away from, the microswitch.The screw mounts from the top, while the spring goes underneath. The spring makes the trigger move forward, away from the microswitch.
__________________
|
|
#7
12-31-2005, 10:07 AM
|
||||
|
||||
|
Re: Need help now.
no leave that in there that is there so you can adjust how far the trigger is from the microswitch
|
|
#8
12-31-2005, 10:09 AM
|
||||
|
||||
|
Re: Need help now.
Alright. Thanks guys.
|
|
#10
12-31-2005, 10:18 AM
|
||||
|
||||
|
Re: Need help now.
Well, seeing as how I can't figure out how to get the spring to stay in the hole, I may have to go without a spring.
Durrell, is there any noticeable chang in how it works?
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
