Spyder Forums  

Go Back   Spyder Forums > Shop Talk - Reviews - Polls > Shop Talk > Custom Shop
FAQ Members List Calendar Search Today's Posts Mark Forums Read

Reply
 
Thread Tools Display Modes
  #1  
Old 02-27-2012, 08:29 AM
spyderon spyderon is offline
New Guy
 
Join Date: Jul 2011
Posts: 19
Default VS3 valve, spring, hammer and bolt in an MR1....

I was doing a tear down and cleaning of a vs3 I just got and started to notice the similarities of the receiver to the MR1. Well, for the hell of it, I installed the VS3 valve, spring, shorty hammer and delrin bolt into my MR1. The bolt needs a modding for a detent grove but other than that it works. The valve on the other hand worked only to about 80% of it's potential as it did not re-cock. I am assuming it is as simple as adding the 3 small relief holes and plugging up the one bigger original hole on the bottom of the receiver? Can anyone verify this or has even done this? I want to be sure before I actually go ahead and look & get xtra vs2/3 parts to actually go thru with this MR1 LP mod.

https://picasaweb.google.com/lh/photo/l1HOADeermKD9c5S3HUcMNMTjNZETYmyPJy0liipFm0?feat=d irectlink

Ron

Last edited by spyderon : 02-28-2012 at 07:28 AM.
Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -8. The time now is 02:09 PM.