![]() |
#1
|
|||
|
|||
![]() Does anyone know to to take it apart? Mine is leaking out of the adjustment screw and I can't rebuild it because I don't know how to take it apart. Thanks!
|
#2
|
||||
|
||||
![]() Pics of said reg? Do you have a manual? That's normally the way most people know ahead of time how to tech things and what parts are involved with the assembly -
__________________
![]() Registered: 6/26/02 Posts: 14,000+ before the old mothership went down Jealousy is the tribute mediocrity pays to genius while feeling alone apposed to smiling adversaries.... |
#3
|
|||
|
|||
![]() Remove bottom hose from ASA
Two small brass screws using the RIGHT size allen key ( I find these to be very fragile) remove all the way Pull reg from block being careful not to damage O-ring pull straight out. On the stainless part ( not anodized ) using an adjustable wrench and a table cloth ( so you dont scratch it) twist the top portion of your regulator off. looking in from the threaded end, you will see a brass disc. Very gently tap the knurled end to basically shake this brass disc out. Its T shaped and also fragile. Remove and carefully inspect the O-ring. Use the right one and replace, should fix your problem, if not post back for a further break down. |
![]() |
Thread Tools | |
Display Modes | |
|
|