|
|
#1
01-15-2010, 07:07 PM
|
|||
|
|||
Maddman Rocket Valve leaking??
I have tried to search for help on this before posting but I haven't really come up with anything yet. I just got my Rocket Valve today in the mail and I installed it. From the first time I aired the gun up it has been leaking. Is this normal (doesn't seem like it should be this way)? It only leaks when the gun is uncocked. Does this mean that the striker is pushing the valve pin in slightly and that I need to adjust the dwell or the SRP knob? I have screwed the srp in most of the way and also I filed it smooth (this was by trial and error, grinding a little at a time and reinstalling). But no matter how much I grind it down it still leaks the same. All of my o-rings are new and lubed and as I said-no leaks when cocked. Any help on this would be greatly appreciated.
Justin 
|
|
#2
01-15-2010, 07:17 PM
|
||||
|
||||
|
Re: Maddman Rocket Valve leaking??
Do you have the Valve facing the right way. The big open should face the front and the small opening should face the striker.
__________________
PBAZ Video of all of Kingman's Spyders as of 2008 VS2:Stock, red body kit, 14" 32* Whisper barrel, Fasta Victor 2:halfbacked, ESP Frame T- Board, VS2 Barrel, Magna Valve, ND Valve Pin, Drilled VA, Polished Striker, Bandit 2 O-ring Delrin Bolt, Custom Trigger, Rex Expansion Chamber, ND Feedneck, T-board
|
|
#4
01-15-2010, 07:24 PM
|
||||
|
||||
|
Re: Maddman Rocket Valve leaking??
What is your marker setup?
EDIT: try tightening the plastic part on the valve
__________________
PBAZ Video of all of Kingman's Spyders as of 2008 VS2:Stock, red body kit, 14" 32* Whisper barrel, Fasta Victor 2:halfbacked, ESP Frame T- Board, VS2 Barrel, Magna Valve, ND Valve Pin, Drilled VA, Polished Striker, Bandit 2 O-ring Delrin Bolt, Custom Trigger, Rex Expansion Chamber, ND Feedneck, T-board Last edited by fatkidfrompbaz : 01-15-2010 at 07:36 PM.
|
|
#5
01-15-2010, 07:39 PM
|
|||
|
|||
|
Re: Maddman Rocket Valve leaking??
I have an Imagine with a PMI reg, trinity front block/LPC, Rocket valve, ACS bolt, stock striker, 32 degrees spring kit.
I have tried to tighten the plastic part but it doesnt help. If that was the case then it would leak when cocked too(i would think)
|
|
#6
01-15-2010, 07:42 PM
|
||||
|
||||
|
Re: Maddman Rocket Valve leaking??
Is the cone misshaped
__________________
PBAZ Video of all of Kingman's Spyders as of 2008 VS2:Stock, red body kit, 14" 32* Whisper barrel, Fasta Victor 2:halfbacked, ESP Frame T- Board, VS2 Barrel, Magna Valve, ND Valve Pin, Drilled VA, Polished Striker, Bandit 2 O-ring Delrin Bolt, Custom Trigger, Rex Expansion Chamber, ND Feedneck, T-board
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
