VS2 hissing down the barrel(fairly new)

[Elfmaze]

OK gys i retired my VS2 a few years ago after i couldn't get it to shoot right in a game. Now i have a game comming up. only play about once a year. And i'd like to finally use the vs2 i bought. I have stock everything besides barrel and a Q loader.

When i shoot a few rounds thru the marker works fine. But today i fired thru 50 rounds and near the end of the rounds the pressure was up around 300 and the round would fire, Valve would stick open causing a HISS. I pull back on the bolt and it stops. I think it may be due to the regulator pressure spike. any ideas? Is this a common problem with these?

Marker may have only around a case thru it because its never worked in a game for me.

[DFSniper]

its your valve. clean it, change the o-rings, maybe a new cup seal.

[Ace24]

You could also lightly sand the cupseal if it's uneven. I've done this to save some cash and for a quick fix.

[Elfmaze]

is there a break in period for the reg? I ran some oil thru the whole thing and then cleaned off the bolt and barrel. Running at 210 psi i didn't get any spikes, did have one recocking issue with the first two rounds but 100 rounds after that work flawlesly. ITs probably waiting for my next game to break again

[DFSniper]

300 psi shouldn't cause the valve to stick. are you using co2 or hpa?

[Elfmaze]

HPA. there was concern last time i played that the pressure from the force feed hopper could be interfering with the bolt. i duno.