|
|
#1
08-14-2009, 10:22 PM
|
||||
|
||||
whats the best to use to help seal thread for air supply?
hello. im installing a steel braided line for the trinity ak47 like expansion chamber and is wondering whats the best material to put on the threads before i tighten them? i know teflon tape is used to help seal liquid on joints, but thats all i found in my garage. i tried the teflon tape and i can still hear a leak. does anyone know what i can use or have any advice/tips? thank you for reading.
__________________
 MR2 -trinity feedneck -haloB (v35, rip and 2 9v battery mod) -AK47 barrel -(crappy) trinity AK47 mag expansion chamber (took off, because it leaked too much) -ACP terminus bolt (took off, because i broke it and it shoots low fps) -MRseries flux wraparound grips 
|
|
#2
08-14-2009, 11:21 PM
|
||||
|
||||
|
Re: whats the best to use to help seal thread for air supply?
okay nvm i fixed it. i used more teflon tape and tightened it. now there is not any obviously big leak.
__________________
MR2 -trinity feedneck -haloB (v35, rip and 2 9v battery mod) -AK47 barrel -(crappy) trinity AK47 mag expansion chamber (took off, because it leaked too much) -ACP terminus bolt (took off, because i broke it and it shoots low fps) -MRseries flux wraparound grips
|
|
#3
08-15-2009, 05:18 AM
|
||||
|
||||
|
Re: whats the best to use to help seal thread for air supply?
I was going to say: Make sure your threads are CLEAN and free from debris (old tape, thread locker) then one or two full wraps of Teflon tape and tighten it enough to be secure. You don't need to strong arm the fittings on...
Good to see you solved it yourself! Good work!
__________________
MR1: chopped barrel w/ MG barrel shroud RedDot on QD 2" rail Q-loader SP8 mod ACP mr1 terminus bolt Palmer female stab w/Lapco vertical ASA wooden grips and stock MR2 (w/o eyes): 12" J&J ceramic barrel 1st gen Trinity MR2 6-stage expansion chamber for MR2 RedDot on riser rail Q-Loaded! SP-8 mod ACP mr2 terminus bolt Dboys SIR shroud Spec OPS commando stock Last edited by sonik : 08-15-2009 at 06:03 AM.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
