|
|
#1
03-30-2009, 05:36 PM
|
|||
|
|||
Ball Stopper Problem
Ok so i was oiling seals and noticed my ball stopper was shredded at the tip, so i replaced with a new one and once i bolted everything down i noticed the bolt was getting caught on the tip of the new stopper. After a few hits by the bolt the tip shredded off again. Is this normal? If not what is causing this?
|
|
#2
03-30-2009, 08:15 PM
|
||||
|
||||
|
Re: Ball Stopper Problem
do you have yout bolt in the right way? one side of the bolt should be channeled out for the detent so it doesnt shread it.
__________________
General Shawn Wayne Tetz, Commander 187th Gaurds Mechanized Rilfe Division. - Includes the 3rd armored brigade from the 34th Gaurds Armored Division. (APC's and armor as well as support elements) -UCSF Armored Division Commander Armored Units -Deep insertion APC -Killer "B" Battle Tank -Troop Transport APC (almost done) -Gun Truck heavy support unit (In the works) -Order of Lenin (1st) -Skyline Sergeant -YGP Rep! -Sector 4 team feild honor recipiant (UCSF)
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
