XSiv Launcher

[XSiv Force]

Here is "Big Boy"

[XSiv Force]

if you guys want i can post how to make one similar to this

[The Pumper]

Pretty nice.

[XSiv Force]

thank ya uch i need to find some place that has a P-40 Warhawk Shark Smile to place around the front of the barrel

[DirtySouth]

How's it work?

[XSiv Force]

well Load nerf rocket in to barrel..............screw the a 12 gram into the quick change while the ball valve is in the off position **VERY IMPORTANT** Then point at target and shoot it will shoot a pocket vortex about 250 ft

[DirtySouth]

Coolio...Sounds dangerous.

[XSiv Force]

Parts needed:
12 gram quick change
2" Diameter X 15" long PVC
2" PVC End Cap
90 degree Steel Elbow
1" long Galvanized Steel Pipe
5" Long Galvanized Steel Pipe
Steel Pipe Ball Valve
Steel Pipe Reducer to fit quick change to rest


All Steel pipe need s to be 3/4"

[Ace24]

How heavy is it?

[XSiv Force]

Instructions:
1) Drill Hole in PVC to fit the elbow into PVC start witha .5" bit and file out to fit
2) Place end cap onto end of PVC and slam cap onto by poping it on ground a few times
3) Using a table top vice clamp screw parts on in this sequence
Elbow-1" pipe-ball valve-5" pipe-reducer-quick change

I suggest using plumbers tape(teflon) on the screw parts to seal leaks.
**Note** The 5" pipe is basically the expansion chamber dont go any smaller than 5". The 12 grams have 500 psi the ball valve is rated around 600 psi

4) Screw the assembly onto the PVC use a sealant as extra protection the stop any other seal around the joints