|
|
#11
05-26-2008, 04:00 PM
|
||||
|
||||
Re: qloader
For you, and Ace and everyone else, here's what I did to replace the SILO. I'll be replacing the electrical tape with duct tape when I get to the store. I drilled two holes on top of the loader and ran a piece of power cable through it (I have tons of wire laying around and that stuff is tuff) than secured it through a coat hanger so I can hang it from a tree in the field. For connecting the hose to it, I tried a bunch of feed tubes, none would fit over both the hose and loader, so I used a heavy amount of tape to make sure it's secure. Works beautifully.
__________________
Quote:
|
|
#12
05-26-2008, 05:18 PM
|
||||
|
||||
|
Re: qloader
Nice setup!
__________________
People crave what they don't have. Vid of me and my Guitar derek_owns_a_guerrilla_radio-School buses don't = target practice, Hoss..  Hossapher-i shot alot of different types MR1 Sniper Rifle Rocket Launcher
|
|
#13
05-26-2008, 06:08 PM
|
|||
|
|||
|
Re: qloader
I'd like to see a video of you using that...very interesting!
__________________
05 Pilot ACS - SPPS Dragon tail trigger, 50 gram switch, CCM feedneck, ACP Bolt, Sticky 3's, Trinity -7 deg. V/A, Rocket Valve, DH Titanium Striker, BL Torp., T board w/ Eyes, Cp Direct Mount On/Off, 275 fps@250 psi VS2 Black to Olive PM6 "All men have fear. The brave ones lay it down and go forward...some unto death but all to victory!" - Kings Guard of Ancient Greece OLD FART CLUB MEMBER My Feedback
|
|
#14
05-26-2008, 06:47 PM
|
||||
|
||||
|
Re: qloader
you know, I was half expecting someone to think that was me in the picture. Like the tree I rigged up? hahahaha. Anyway, I may be able to do something later this week.
__________________
Quote:
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
