|
|
#11
04-28-2008, 04:57 PM
|
||||
|
||||
Re: Front and Rear Slack
Not bad, I might go out and pick one up at my local paintball store tomorrow. If I can get it for 12$ I will definitely get it, I have that in my wallet currently.
I added a little stopper to the back of my trigger (temporary) to see if it would work. I will have a picture of it, and since I am bored maybe a video. Picture  The piece is the button part on a pen. If you watch the video you will see. Video I would embed it but that might be annoying, I don't think it would let me either.
__________________
"Lord, I believe; help my unbelief!" -Mark 9:24 Last edited by OSOK : 04-28-2008 at 07:07 PM. 
|
|
#12
04-29-2008, 08:36 PM
|
||||
|
||||
|
Re: Front and Rear Slack
Sorry it took so long, your other thread reminded me.
This set screw takes care of the front slack. All I did here was drill and tap a hole for a set screw. 4-40 was what I tapped it to.   This one takes care of the rear slack. Similar to the other one, just drilled and tapped a hole so I could put a set screw in there. I think this one I tapped out to 6-32.  
__________________
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
