vs1 problem!!!!!!!

[steve22]

yo
i just got a spyder vs1 and have shot it a few times and after i start walking the trigger the gun will shoot 4or7 ball or some times will go full auto and un cock (in semi mod)
i am running c02
anyone else have that problem or can help me out
thanks

[king-man]

your out of co2 probably, if not make sure your lubed up good

[steve22]

i lubed evering thing that should be lubed and put oil in were the tank hooks up and i have a 3/4 full tank
thanks

[king-man]

hmm, whats the temp where you are?

[steve22]

50 degrees f -70degrees f

[king-man]

so it shouldnt be freezing up into pure liquid, i dont think, do you have a leak anywhere, even a little one, have you ever disassembled it?

[DirtySouth]

Hmmmm...This happened to my VS1 when I first bought it. Try adjusting your trigger so that it's not so bouncy. What happens is that the vibration of a shot fired causes the gun to misfire again and again. That worked for me, hopefully it will work for you.

[steve22]

after going through about a case it semm to have gotten better
also loading it up with oil seemed to help
but when it does go full auto i can hold down the trigger and it will stop
than i can start walking again
thanks

[king-man]

make sure your frame screws are tight

[bigred76]

Your trigger is bouncing if that fixes it. Adjust it further away from the activation point either by the set screw that adjusts activation point or by the screw that affects the fore-travel. Make it about 1/16"-3/32" from the point that it touches the switch.