clamping feedneck.

[DFSniper]

so i'm in the market for a clamping feedneck. the two i'm looking at are:
NDZ Low Rize
or
CCM No Rise

but i'm open to other suggestions since i know nothing about clamping feednecks. the hopper is an Eggy3, and i'll cut the feedneck, so it looks like the NDZ will actually give me a lower profile, PLUS, it comes in red/black, so it'll match the color combo of my gun.

[Hossy]

I like the NDZ better, even if it costs a few dollars extra.

[xxcarlosxx]

this is the one i got on my pilot. its really nice and low profile, btw which gun r u getting this 4?

[HelpDeskHustler]

I had a ndz. it was nice.

[DFSniper]

Originally Posted by xxcarlosxx

this is the one i got on my pilot. its really nice and low profile, btw which gun r u getting this 4?

my electro spyder. my mech has a super-low profile plastic hopper on it due to a little ghetto modding. i put electrical tape around the neck, cut the stock neck of the gun, trimmed the feedneck of the hopper, slid it over (its a perfect fit) and it sits about an inch off the gun.

[TheDarkShadow]

make a spego feedneck

[DFSniper]

i wouldnt mind it, if someone could link a good ego feedneck. that would actually lower it a lot more too!

[TheDarkShadow]

http://www.actionvillage.com/is-bin/...oAAAEJ8imSCSdd there you go

[DFSniper]

hmm. i'm seriously considering it. that would give me a few SOTM cool points too...

[TheDarkShadow]

wellif it doesnt work out, sell the ego feedneck and get an aftermarket one, worst case senario, your out a few bucks and a stock feedneck...