FPS fluctuations with HPA ??

[SkinWalk3r]

I am using an X-Radar Chrono. Running HPA 68/4300. I seem to be bouncing between 270 - 312 !!!!!! why would this be and how do I cure it. Using a remote BTW

[DFSniper]

get a regulator/higher flowing valve. thats about the only thing you can do about it.

[SpyderMan723]

Originally Posted by DFSniper

get a regulator/higher flowing valve. thats about the only thing you can do about it.

Hpa doesn't guarantee steady pressure, its just a better air source for your marker.

BL torp's are pretty cheap, and they look like they will fit under the handguard.. ill tell ya when mine gets here

-Tj

[DFSniper]

if you're using HPA, get a CP since it has the fitting in the bottom already.

[SkinWalk3r]

regulator/higher flowing valve are they the same thing or two different things ?

[DFSniper]

different things. a good reg, as listed above, and a 32* magnaport valve should help a lot.

[SkinWalk3r]

so what does this valve do...how much work is involved AND where is a good place to buy it. Is there one made specifically for the MR2 or can I use a Spyder one ?

[DFSniper]

its pretty much a milled-out spyder valve. they're $10 without the valve pin and $15 with the valve pin. just about any online site (except actionvillage) sells them. try compulsivepaintball.com or ebay.

[druid]

wait wait wait...

Your MR is electro right? Did you happen to mess with any dwell settings of the board? Too low of a dwell setting will cause high fluctuations over a chrono.

Also, is there an inline reg on it? If so, you may need to tear it down, clean and regrease it.

[SkinWalk3r]

"dwell settings of the board" ???????????????? I have no idea what that is. I have never made any changes to the board. Are they physical switch settings or programming settings. I am just asking becuase I took the whole thing out while cleaning and I want to make sure I didnt knock anything on or off ?