Loader for Pilot ACS

[mr1newbie]

What's a good electronic loader for the Pilot ACS? I was thinking a Halo, so with upgraded electronics you wouldn't have to get a faster loader. Thanks

[Sandman_Bravo]

I am partial to the Empire Reloader B. They are sound activated and have no problems keeping up with any marker.

[FAQTO]

i ran an eggy3 with no problems but switched to a halo-b, or go with a empire reloader-b as sandman bravo said
james

[Solar]

I have a Empire Reloader 2 (not force fed like the B) and it does ok. I can out shoot it sometimes (if the hopper is full it can usually keep up). But I recently picked up a Halo B and had some problems. I kept having balls break in the chamber. I think i just had bad paint though because most people i've talked to have no problems with a Halo B.

If you are thinking about upgrading your board or ever getting a higher end gun, I would deffinately spring for a halo B or a Reloader B. (you can get them used for pretty cheap - Got my halo B for 30 Bucks.)

[sloazzpilot]

i have the standard empire loader that is sound activated, it works great and it was not very costly. also it is a quiet loader, out of 5000 balls i have chopped one in the hopper, the battery in the marker was going dead, but other than that great hopper.

[bigred76]

I'd sugest a Reloader/Halo B as well. If you ever decide to upgrade, it's a loader you can keep and expect to keep up with you for a little while.

[xsvly-fat]

jr, it works great with mine the battery life is bad but if you get a chip its nice.

[mr1newbie]

Thanks for the help!

[paintkid12]

I used to run an empire reloader 2 then i got a vlocity wich works really well.lots of people say that the force feed is really loud but i dont notice it at all and keeps up really good wit my pilot with t board. only thing is when u get low on paint 20 balls or so it tends to send the balss all over.vlocity are allso easyier to clean/ take apart

[mr1newbie]

What about a VL Revolution Force? Are they okay?