palmer stabilizer

[sphven]

which of the stabilizer's do i need to get for my vs2 if i am using co2 and have the stock front block?

[Theheroguy]

uh idk about stabilizers but this would work if you replace the stock asa with it
doolie

[Motorhead]

Use a "MALE" stabilizer .... Its screws right into your front ASA/LPC block.
You will need to replace your bottom line ASA because the Palmer unit uses standard 1/8 NPT fittings. New hose or macro-line will be needed as well.

[Theheroguy]

the vs stock lpc block isn't threaded for regs

[Motorhead]

Ah, my bad info & mistake.

[sphven]

it's alright i think i've figured out what i need to do but it's going to be more expensive than i wanted. I'm going to need the trinity front block and a male stabilizer and then a new asa to replace the broken one on the vs2

[Hob Hayward]

You could potentially get a female stabilizer, that way you wouldn't need a new ASA.

[DRAGON]

Originally Posted by Hob Hayward

You could potentially get a female stabilizer, that way you wouldn't need a new ASA.

I would go that route as you wouldn't lose any volume in the front grip as well. You'd need mounting rings for the female -

[NeedForSpeed]

I have an ASA you could have for a few bucks. I also know where you can get a chrome palmers stab for $40. Interested?

[sphven]

Originally Posted by Hob Hayward

You could potentially get a female stabilizer, that way you wouldn't need a new ASA.

what really sparked my search for a stabilizer was that my asa had broken and i was going to need an inline reg and i heard that the stab. handled co2 well so i was shooting for one of those