|
|
#1
06-09-2007, 07:11 AM
|
|||
|
|||
To ring? or not to ring? ACP O-ring question
Just wanted some feedback on ACP bolts and if you got a ringless one or two ring? or a 3 ring with the top ring removed? so if you have any of these bolts in your mr-1, post away and let us know what you think about it!
 
|
|
#2
06-09-2007, 08:07 AM
|
||||
|
||||
|
Re: To ring? or not to ring? ACP O-ring question
Get 2 o-rings. I'd say o-rings are always better than no o-rings.
__________________
05 Imagine Palmer stabilizer Maddman Rocket valve Trinity Front block IPS Sunbear Bolt Dark Horizon titanium striker Green/silver VSC CCI Phantom Red/Black PMR SE
|
|
#3
06-09-2007, 12:28 PM
|
||||
|
||||
|
Re: To ring? or not to ring? ACP O-ring question
get 2 orings it's a lot better than none
|
|
#4
06-09-2007, 02:41 PM
|
||||
|
||||
|
Re: To ring? or not to ring? ACP O-ring question
I agree with O-rings ....
Just added a 3rd O-ring to my Billet Delrin bolt. Cut another groove @ 1/8" back from bolt face to better seal the breach  .... It did just that, gained 25/30 FPS and allowed me to back down pressure even further.So long as the o-rings are just a "Zero/Zero" fit and do not cause more drag on the cycling of the bolt, it's ALL better in the end 
__________________
2K4 Green Spyder Imagine. Palmer Pursuit Shop 2K RF BLAZER. Sheridan PGP pump. Classic Auto Mag. CCM S-5 Pump. Paintball ... Most fun you can have without taking off your pants !
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
