Broken Trigger Frame

[boogieman69]

I am trying to salvage a broken trigger frame. I would really like to be able to use this frame because it is a single trigger style that will work perfect for my pump project. Below is a pic of where this frame is broken (not the broken one). Anyone have any ideas? I am floating a few around but wondered if anyone else had something better. Thanks all.

[NeedForSpeed]

super apoxy? Some of the stuff out there is supposed to be able to withstand lots and lots of pressure. I have some on one my bass drum beaters for drums and it holds up nicely untill i buy a new beater.


Is this just a single mech frame? I could send one to you for $5 if you want or however much the shipping costs depending on where you live.

EDIT: I just realized you want single-trigger so scratch that^

[boogieman69]

Its a single trigger mech frame that I'm trying to salvage. Theres a pic below.

[Nenkitsune]

i dunno. i actually only have the front frame screw holding my frame on atm. it holds up really well. but it's also metal. i'd say your best bet would be some sort of epoxy or glue. maybe gorrila glue?

[Kenny_McCormic]

dremal a channel across the break and fill it in with jbweld. be sure to give it 24 hours to dry

[Hob Hayward]

Pin it.

Drill two small holes (paper clip diameter) in both halves of the frame (line-ing up EXACTLY) and use two cut pieces of a large paper clip to put in the holes, epoxy it all together, and it should be much stronger.