spyder mr1 problems.

[NoRcO_bOi]

Hey, I am having a problem with my Spyder mr1. It won't cock. I put all the parts in pull back on the thing that is attacked to the hammer and it won't catch the spring just springs it back forward. Do you guys know the problem?

[Hob Hayward]

Is your grip frame attached to the gun? If it is, make sure its on tight.

[NoRcO_bOi]

How do I make sure it is tight?

[NoRcO_bOi]

it isn't even cocking when I don't put my co2 tank into it:S

[Kenny_McCormic]

something is wrong with your trigger frame

[NoRcO_bOi]

alright, can you tell me what? and how to fix it please?

[Taillo]

If your problems began after disassembling the bolt, you may have reassembled it wrongly. I had this problem once and i was not able to fix it till i reassembled it right. One way to see if it is wrongly assembled, push down the cocking knob, if it goes way lower than usual, its not correct. Try to disassemble the bolt and reassemble it, you may find what is wrong.

[kidonfire]

tighten the screws on your trigger fame first. If that doesn't work then check the sear to make sure it isn't rounded.

[alam3503]

hammer upside down??? I dont think that is possible. but the sear sounds like the problem

[Ace24]

Originally Posted by Taillo

If your problems began after disassembling the bolt, you may have reassembled it wrongly. I had this problem once and i was not able to fix it till i reassembled it right. One way to see if it is wrongly assembled, push down the cocking knob, if it goes way lower than usual, its not correct. Try to disassemble the bolt and reassemble it, you may find what is wrong.

Not true. Mine is assembled right and I can still push the cocking pin all the way down to the frame.

Your hammer is upside down. That or your trigger frame isnt attatched right. It also could be that your bolt itself is upsidedown. Make sure the slot for the detent is facing the feedneck side of the gun when putting it back in.