![]() |
#1
|
|||
|
|||
![]() I could take my hosing off my gun with my hands... is it only suppose to be hand tight?
__________________
-Anth Spyder Electra ACS '05 Proto 1 Piece Barrel Pure Energy 72cu 3000psi Reloader B with Rip Drive ACS Bolt Too come; Trinity Feed Neck T-Board Electra Club Founder #2 |
#2
|
|||
|
|||
![]() where is the hopsing? to the gas-trhu grip or the bottomline where the tamnk screws in? if its to the gas thru grip i can also do that but its nothing to worry about. if its to the bottmline where the tank screws in u might have a problem
|
#3
|
|||
|
|||
![]() both ends
__________________
-Anth Spyder Electra ACS '05 Proto 1 Piece Barrel Pure Energy 72cu 3000psi Reloader B with Rip Drive ACS Bolt Too come; Trinity Feed Neck T-Board Electra Club Founder #2 |
#4
|
|||
|
|||
![]() to the place where u screw in the tank u might wanna put some loctite or teflon tape around it and screw it back in. dont worry about the gas thru grip.
|
#5
|
|||
|
|||
![]() Ta, will find out if i leak tomorrow - if so got a back up electra
![]()
__________________
-Anth Spyder Electra ACS '05 Proto 1 Piece Barrel Pure Energy 72cu 3000psi Reloader B with Rip Drive ACS Bolt Too come; Trinity Feed Neck T-Board Electra Club Founder #2 |
#6
|
|||
|
|||
![]() nice
![]() |
#7
|
|||
|
|||
![]() it was fine - without loctite or telfon tape
__________________
-Anth Spyder Electra ACS '05 Proto 1 Piece Barrel Pure Energy 72cu 3000psi Reloader B with Rip Drive ACS Bolt Too come; Trinity Feed Neck T-Board Electra Club Founder #2 |
![]() |
Thread Tools | |
Display Modes | |
|
|