![]() |
#1
|
|||
|
|||
![]() Hi! I hope someone can help me out here. I'm having a little trouble wading through what might and might not work here. I am looking for some kind of anti-chop bolt upgrade for my Sonix 07. Can anyone post a link or something that would point to the proper bolt for the job?
Thanks! -Scionic
__________________
No good to fight, but if must fight...win! -Kesuke Miyagi ------------------------------ Marker Setup (So Far): Titanium Spyder Sonix '07 J&J Ceramic 14" Barrel VL Revolution Electronic Hopper |
#2
|
||||
|
||||
![]() same! check out "Bolt help"
__________________
http://pbgoods.com/index.php?id=12863 |
#3
|
||||
|
||||
![]() I have a JAM Bolt. its an anti-chop bolt. A pic is in my b/s/t post.
EDIT: Keep forgetting its not in my sig. http://www.spyder.tv/forums/showthread.php?t=11781 |
#4
|
|||
|
|||
![]() oldiornmudder- That one doesn't fit because the pin doesn't slide up to allow it to fit into the body.
|
#5
|
||||
|
||||
![]() oldironmudder-no longer awol ?
|
#6
|
|||
|
|||
![]() Yea they stopped milling out the back for a traditional bolt, cuts out a machining step. A TES JAM bolt might work.
__________________
Stock ZAP AMP generator with polished valve assembly Spyder Victor with a modded CORE derlin bolt, polished striker and polished valve assembly BEING POOR SUCKS |
#7
|
||||
|
||||
![]() Kinda sorta I get on when I can at work. Quote:
|
#8
|
||||
|
||||
![]() Quote:
Edit: couldnt find one so I drew one... ![]() Last edited by TheDarkShadow : 03-07-2008 at 01:12 PM. |
#9
|
||||
|
||||
![]() http://www.spyder.tv/section/support...yder_sonix.pdf
I just looked here & the pull pin is the bolt-striker pin. I would guess kingman didnt cut between the tubes like on older bodies. You could use a Timmy Jam bolt. Or a top cocking ACB. |
#10
|
||||
|
||||
![]() Where can i get a JAM bolt and what is a TES JAM bolt?
__________________
http://pbgoods.com/index.php?id=12863 |
![]() |
Thread Tools | |
Display Modes | |
|
|