Spyder Forums  

Go Back   Spyder Forums > Spyder Markers > Mechanical Markers
FAQ Members List Calendar Search Today's Posts Mark Forums Read

Reply
 
Thread Tools Display Modes
  #1  
Old 03-14-2008, 02:03 PM
boughtasonix's Avatar
boughtasonix boughtasonix is offline
New Guy
 
Join Date: Nov 2007
Posts: 10
Default Need some help with the bolt pin and ball bearing!

Ok, so i disassembled my sonix all the way. I didn't know there was a bearing in there, and i dont know how to put it back in. As I said, I have nothing in place. Thanks for helping, if you can post.
Reply With Quote
  #2  
Old 04-09-2008, 07:51 AM
davmitchell77 davmitchell77 is offline
juggalo
 
Join Date: Feb 2008
Location: Pine Springs, TX
Posts: 82
Default Re: Need some help with the bolt pin and ball bearing!

there is no bearing in there.
how "complete" is the dissassembly? did you remove the valve?
In order from valve to rear of marker (lower tube) you should have: striker with oring, striker spring, rubber buffer (big fat rubber washer), spring guide (looks like a nail), spring guide shim (sometimes there, sometimes not- looks like metal washer with no hole), and rear plug. the shim, spring guide, and spring feed into the hole in the rear plug.
if you took the valve out, put it (with orings) in with the lip towards the front of the marker. then the valve guide (metal star) goes on the cup seal (plastic pushpin looking piece of valve), held in place by the valve spring, and stick the whole shpeel into the front of the lower tube. make sure the valve stem drops into the valve. put in the front plug.
Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -8. The time now is 09:19 AM.