|
|
#1
01-13-2006, 04:26 AM
|
|||
|
|||
leaking
is coming from where I screw my bottle to my gun...
will this be the bottles O ring that is causing it? (it looks ok?) 
__________________
-Anth Spyder Electra ACS '05 Proto 1 Piece Barrel Pure Energy 72cu 3000psi Reloader B with Rip Drive ACS Bolt Too come; Trinity Feed Neck T-Board Electra Club Founder #2 
|
|
#2
01-13-2006, 05:53 AM
|
||||
|
||||
|
Re: leaking
looks can be deceiving. Take it off and closely inspect it. Or just replace it with new one. Tank o-rings are super cheap.
Also is it coming from the side with the bottle or the side with the steel braided hose? If it is the latter it could be the fitting seal. Take it apart and re-Teflon it, make sure not to get the tape on the inside of the threads. HacKeR
__________________
Quote:
|
|
#3
01-15-2006, 12:11 AM
|
|||
|
|||
|
Re: leaking
i'd just replace it ... the o-ring usually starts to change colors when it starts to go bad .. i usually replace it before that. It could also always be the hose as hacker said. If you don't have teflon you can use blue loctite. Teflon's cheaper ... like 3 bucks for 5 rolls or so
__________________
KUSA Feedback 47+/0- PBN Feedback 41+/1- New PBN Feedback 18+/0- EBAY Feedback 9+/0- Ion Owners Feedback 3+/0- Automags Feedback 3+/0-
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
