Spyder Forums  

Go Back   Spyder Forums > General Spyder Discussion > Picture and Video Pages
FAQ Members List Calendar Search Today's Posts Mark Forums Read

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 03-23-2012, 10:01 AM
spyderon spyderon is offline
New Guy
 
Join Date: Jul 2011
Posts: 19
Default Custom LP MR2 w/eyes Blance Valve internals @ 240psi

After toying around with my MR1 & VS3, I had an idea! Since the body looked more or less identical on the inside, I figure why not run the LP Balance valve from the VS3 in a MR1? Well it looked like it would work during a test run swap, but I had to plug the 1 hammer bleed hole and drill out 3 smaller ones, but why bother on a simple MR1... I need something with eyes! I got a hold of a busted MR2 w/eyes, fixed it and then did my thing...... plugged the 2 valve pin retainer holes, plugged the air bleed hammer hole, drilled 3 smaller bleed holes, added the Spyder balance valve, spring & shorty hammer, then modded the fore grip to fit a v2 LP CP Regulator with gauge, dremmeled the Bolt air entry hole to look like a VS3 bolt and also added epoxy resin to the inside of the bolt to form an angled air flow just like the VS3 bolt , also a JJ 14" Barrel , Rotor and with a small amount of milling, I added the VS3 velocity adjuster. Tested out today and WOW, very impressed. I only wish I could get my SLY Carbon barrel kit to fit, but that may be the next mod.

I will be using it tomorrow at Yankee Paintball to give it it's final test!

Here is a link of it shooting in Full auto (semi would have been boring)

https://picasaweb.google.com/1087931...eat=directlink

Last edited by spyderon : 03-23-2012 at 10:57 AM.
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -8. The time now is 06:01 PM.