spyder mr2 issues

[Jman21]

i have a mr2 and never use it. I pulled it out yesterday and it wont fire. electronic trigger works on all 3 modes. when a co2 is connected it just spits the ball out and you have to re-cock the lever, tried on 3 different tanks. I know the tanks are good, we tried them on a different gun. i took it apart and didnt see anything blocking. any ides or could i have missed something

[Talon]

Sounds like an air problem. I would start with the striker o-ring, change that out and oil it. Then check and see if it works.

[Jman21]

Were do I find the ring at, I dont know much about the gun

[shunut]

Definitely an air problem, sounds like you aren't getting enough pressure. Is the tank new/recently filled? Have you ever taken the gun completely apart (I ask this because it could have been put back together incorrectly)?

[Talon]

I would first try to find an O-ring at your local paintball field. If you can't get to a paintball field. Go here, this will is a complete o-ring rebuild kit.
http://www.orings-online.net/index.p...duct s_id=294

[Jman21]

Originally Posted by shunut

Definitely an air problem, sounds like you aren't getting enough pressure. Is the tank new/recently filled? Have you ever taken the gun completely apart (I ask this because it could have been put back together incorrectly)?

yea I got it refilled so it is completely full, when the tank is one another gun, the other gun fires with no problem

[Jman21]

oh and no its never been taken apart, i took it apart today too see if there was a clog in the line other than that no. its aggravating cause i never use it. i will say i left the tank on for a little while, could that have caused something

[shunut]

Leaving the tank shouldn't cause the problem you're having. Try lubing all moving parts, valve pin, striker and bolt. Also, once in a while some how, the bolt gets put in upside down, its happened to me, so make sure that the opening on the side of the bolt is facing down.

[Atwaterpaintball.com]

You can go on youtube to look on how to take the paintball gun appart. it may not be the exact one. It could be o-rings that may be bad depending on your gun. it can have up to 5-8 o-rings. Check out

How to Clean Your Paintball Gun, Spyder Marker ...

.