Custom Ball Detents (Instructions)

[D4RKKNIGH7]

PLEASE COMMENT


Well I Had Some Ball Detent problems but then i thought ill make my own so i did and i found that my idea work perfectly so i made some instructions so you guys could try it I Have a link

Instructions:

Step 1: get The Items You Need

2 Pins (or 3.5mm ball bearings)



1 Pen (Not Working)



Step 2: Pulling out the stick

pull The Stick Off The Pins with some pliers



open the pen and get out the spring and cut it in two with the pliers




Step 3: Putting detents in Gun

Remove your eye covers from the gun
take out detents that are in there
put pin head into detent hole



place the spring half onto pin head



carefully place the eye cover back on and screw it on



do the same to the other side

then looking through the barrel should look like



Step 4: Firing the gun

Well Just Fire it

Video Coming Soon

Please Visit PBWorld Also, link is in my signature

[TheDarkShadow]

that's pretty cool

[fatkidfrompbaz]

nice

[slim and shady]

Hey great job I like that

[D4RKKNIGH7]

Instructions now in first post

[stevet]

Man you rock,
ive been chewing thru them and tried your pin idea and it works so sweat, and the balls are actually flying straighter and further at same velocity setting.
amazing $1.50 for a couple of pins and a pen instead of $10 for a set of actual ball detents priceless. you should sell the idea to Spyder

[shunut]

Very cool and creative

[Lawpass]

Nice idea!

[vikingshadow]

Nice idea - even when it was done back in 2009, LOL! Holy necroposting, batgirl!

Just kidding - it is a good idea.....never got to try it, actually.

[mazzon]

my holes on my vs1 didnt fit the pin heads. and i broke ,my eye covers so imade some out of high temp hot glue and used the glue as ball dents seemed to work with test fire . looks ghetto.