|
|
#1
01-24-2011, 07:03 PM
|
||||
|
||||
why does stock work ?
Why would the stock bolt work and the hush not ? Nothing looks abnormal.
__________________
09 PILOT w/eyes Tech-T Hush bolt J&J Elite barrel kit Halo too 
|
|
#2
01-24-2011, 07:23 PM
|
||||
|
||||
|
Re: why does stock work ?
did you change the o-rings on the hush bolt? it sounded like that was your problem before
|
|
#3
01-25-2011, 09:34 AM
|
||||
|
||||
|
Re: why does stock work ?
The Hush bolt might be a little tight with the o-rings it comes with. Replace them with the black o-rings that comes in your parts kit.
|
|
#4
01-25-2011, 07:17 PM
|
||||
|
||||
|
Re: why does stock work ?
^^ Listen to this guy. He knows his stuff ^^
__________________
 KUSA Old School Alumni #4939Registered: 6/26/02 Posts: 14,000+ before the old mothership went down Jealousy is the tribute mediocrity pays to genius while feeling alone apposed to smiling adversaries.... 
|
|
#5
01-26-2011, 04:01 PM
|
||||
|
||||
|
Re: why does stock work ?
I changed out the black o-rings and its still not recocking. Any other ideas ? Do you think I need a different spring ? If I am going to change the spring, I should put one with less resistance, right ?
__________________
09 PILOT w/eyes Tech-T Hush bolt J&J Elite barrel kit Halo too Last edited by pablodiablo : 01-26-2011 at 06:10 PM.
|
|
#6
02-24-2011, 03:25 PM
|
||||
|
||||
|
Re: why does stock work ?
Without engaging the bolt pin to the striker, slide the Hust bolt in your marker and slide it back and forth. Does is feel like the bolt is dragging or have a lot of resistance? If it does, then the remove the o-rings and try it again. If the Hush bolt slides in the breach freely, then the cause of the resistance is the o-rings. Try and find thinner o-rings to use on the Hush bolt. Also, turn in the velocity adjuster in slightly.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
