|
|
#1
05-09-2010, 01:44 PM
|
||||
|
||||
co2 purge above trigger
i had the trinity expansion mag installed, but it was giving me way to much leak problems. so i re-installed the stock setup. i think i got it all installed so i connected the co2. fired 4-5 blank shots in my room(worked fine) and then it started to purge the co2 from the hole above the trigger. i had to remove the co2 tank or it would waste it all. did i install something wrong or am i missing something?
 thank you in advance for your help.
__________________
 MR2 -trinity feedneck -haloB (v35, rip and 2 9v battery mod) -AK47 barrel -(crappy) trinity AK47 mag expansion chamber (took off, because it leaked too much) -ACP terminus bolt (took off, because i broke it and it shoots low fps) -MRseries flux wraparound grips 
|
|
#2
05-09-2010, 07:37 PM
|
||||
|
||||
Re: co2 purge above trigger
nvm it started to work again when i took it apart and put it back togther
__________________
MR2 -trinity feedneck -haloB (v35, rip and 2 9v battery mod) -AK47 barrel -(crappy) trinity AK47 mag expansion chamber (took off, because it leaked too much) -ACP terminus bolt (took off, because i broke it and it shoots low fps) -MRseries flux wraparound grips
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
