MR1 shooting multiple balls

[bigred76]

That was for the VS series. You cannot do that with the MR1.

[rayray88]

You could just get them from here if you like.
I would recommend the hard one (red) cause the MR1 is a mech marker.

[phyber]

Originally Posted by rayray88

You could just get them from here if you like.
I would recommend the hard one (red) cause the MR1 is a mech marker.

thanks a ton!!

my buddy found a website that sells the factory replacements, i ordered 3 to be on the safe side. i'll order this set as well. for the price there's no reason not to!

i had a screw-strippage issue when trying to get the feed neck off, but thats settled now, and replaced all 3 with stainless steel phillips head screws.

is there any mod to make sure to keep the detent in? i cant really tell, but it seems to me maybe some kind of "anchor" could be made to keep the detent from jumping out into the barrel?

[rayray88]

Um if you look where the detent goes you'll see that the space or the inset circle in the marker. The little hole is only for the nipple part of the detent so it's not really going to fall through. The only thing that can happen is that, the little nipple part get sheared off because the bolt slides over it. So the problem with the earlier detents was the they get sheared off (most likely your problem) and then there's now way to really regulate the paint flow into your gun.

[sqirmymr1]

they do sell metal ones for some guns maybe you could look into that