|
|
#1
08-18-2009, 01:47 PM
|
|||
|
|||
need help..with stock?
so i have a little dilemma...a long time ago i purchased a stock and once it got hear realized that it replaced my velocity adjuster...well that was fine i just bought a sping kit problem solved...fast foward to now...im starting to do lp mods and realized that i should probably have a stock that didnt cover my adjustments so i could better dial in my reg and velocity. so my question is...is this a big deal or will changing vlocity with springs only and no hex dial adjustment make it harder to be consitant? if so where do i buy a car stock that goes in the top hole?
__________________
MR2 W/EYES acp 2 o-ring bolt timmy detents tadao board w/m7 chip qloader 500 round system mr2 6 postion car stock (w/cheek pad) jj 6in barrel with M16 sight and apex tip Madd Man Rocket Valve Dye Hyper II regulator Redz Grenade drop ASA Custom foregrip warfare grips tactical 3pt sling 40mm red/green dot scope TRUspec MultiCam shirt and pants 
|
|
#2
08-18-2009, 03:43 PM
|
|||
|
|||
|
Re: need help..with stock?
as for where to buy the stock...ebay, amazon, etc...
and i'd go with the screw adjuster with the light spring, when using a reg...
|
|
#3
08-18-2009, 04:56 PM
|
|||
|
|||
|
Re: need help..with stock?
well i know the general places to buy the stock but i need to know which one what is it i type in that will give me the right stock
__________________
MR2 W/EYES acp 2 o-ring bolt timmy detents tadao board w/m7 chip qloader 500 round system mr2 6 postion car stock (w/cheek pad) jj 6in barrel with M16 sight and apex tip Madd Man Rocket Valve Dye Hyper II regulator Redz Grenade drop ASA Custom foregrip warfare grips tactical 3pt sling 40mm red/green dot scope TRUspec MultiCam shirt and pants
|
|
#4
08-19-2009, 12:03 PM
|
|||
|
|||
|
Re: need help..with stock?
this is the one to get:
http://cgi.ebay.com/Kingman-Spyder-M...p3286.c 0.m14 just gotta make sure its not the one with the notch on top
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
