Adjustable regulator

[agent1940]

Hey guys I'm looking to make my gun run on LP. So far I have a New Designz valve, 32 degrees spring kit, HPA tank, and a ACP two o-ring bolt on its way. I think I read up that a adjustable regulator is needed. If so whats a good regulator that fits where the ASA goes. Also, what ACP striker fits the mr2 and will make a difference.

[bigred76]

Palmers Stabby is the only bottomline adjustable regulator I can think of short of adjustable tanks.

[SundragonPPS]

Can't go LP w/o a reg. It's a must or you cannot lower the pressure which is the whole point. You can add a bottom line reg as Red suggested or remove the front plastic shroud and use a vert reg. Removing the front plastic shroud somewhat takes away from the good looks of the MR2 in my opinion. That's just one person's view though. I have seen someone that tight fit a vert reg into the hole of the shroud as well.

[agent1940]

I'm using a Trinity AK-47 expansion chamber so a vert reg is not an option for me.

[slim and shady]

Then go with what Red sugested. Your choices at this point are more limited.

[agent1940]

Which ACP striker will fit the mr2.

[sonik]

I don't know that ACP makes a MR2 specific striker... E-mail them to check--->here

[DFSniper]

A standard spyder striker should fit. As for reg, if you can't pick up a vs2/3 reg, get a palmers bottomline or maxflow adjustable tank reg