|
|
#1
02-07-2008, 05:04 AM
|
||||
|
||||
Another LP thread
I recently obtained some parts for my spyder pilot to go LP. Now if I put all this crap together, are there going to be problems if I hook up co2 as opposed to HPA. Here is what i have:
Evil Detonator Trinity Front Block Trinity Drop Forward On/Off ASA Macroline Is there anything else other than a maddman that I need to go LP w/o probs and do I need to purchase an HPA?  
|
|
#2
02-07-2008, 06:05 AM
|
|||
|
|||
|
Re: Another LP thread
Might want to double check that the detonator is compatable with CO2. I didn't think it was but i could be mistaken. Everything else seems good.
I would recomend HPA though. Wish i had gotten that from the start. I run CO2 with an anti syphon tube and a palmer stabilizer as my reg. It works well but it gets REALLY cold some times...lol
__________________
Pilot owners club #51 Pilot ACS, Dye Boomstick Barrel, Clamping Feedneck, Palmer Stabilizer, Trinity Front Block, Madman Rocket Valve, Polished/Cupped striker, T-Board, 50g switch, Dye Sticky Grips Last edited by Solar : 02-07-2008 at 06:05 AM. Reason: Typo
|
|
#3
02-07-2008, 09:28 AM
|
||||
|
||||
|
Re: Another LP thread
I'm not sure about the detonator. I know that the BL Torpedo and the Palmer's Stabilizer both work really well with co2, if thats what you are going to stick with. If you are going to stick with co2 make sure you have an anti-syphon tank.
As for other upgrades you might need to consider: Bolt Striker Polish all internals
__________________
|
|
#4
02-07-2008, 10:56 AM
|
||||
|
||||
|
Re: Another LP thread
if you ever need any help or questions on doing custom mods on your marker go to otters page
here is the low pressure info, read it all and you can't go wrong  just scroll down to "Project LP" 
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
