home mods vs2?

[awwjeezitscrazy]

what mods can be done to the vs2 to run at a lower pressure?

people have claimed to have done but they havent spilled the beans on how it was done...

im guessing polishing and cupping striker and possibly porting out the valve?

input would be appreciated!

thx

[Doc77]

How low do you want to run? I'm running at about 220psi and getting 280fps with the velocity adjuster in 1/2 turn. When you first get your VS2, run it at around 250-275psi until the reg breaks in, which in my case took a few boxes of paint. Upgrading your reg and enlarging your LPC will allow you to operate at lower pressures. But go too low and you'll have problems with your recharge rate at high ROFs. I've heard some guys claim that they run at 180psi....I'm not sure if I believe them though.

[spray and pray]

I can get mine 180-185 but when I hit really fast it uncocks. 190 is what I like to run it at without any problems now. But then again my vs2 is highly upped.

[king-man]

so wat did u do I got a cp reg and mine runs at 220 alright

[swoosh81]

Originally Posted by awwjeezitscrazy

what mods can be done to the vs2 to run at a lower pressure?

people have claimed to have done but they havent spilled the beans on how it was done...

im guessing polishing and cupping striker and possibly porting out the valve?

input would be appreciated!

thx

Check the VS Series Info link in my sig. or better yet I'll make a post of the info. here also.