Help!!

[onlyuseVicfirthSticks]

my gun is not working............
i went paintballing and the balls would just fall out of the barrel so i emailed spyder and they said that the ball detent or stopper is missing?
so i looked on ym gun and there was nowere for the ball stopper to go in my gun? can anyone show me a picture of there or tell me why my balls are falling out of my barrel?

[tater_salad]

It is the little black rubber thing there should be a hole when you take the feedneck off and it should be there if you have one.

[vikingshadow]

The ball detent should be located somewhere near where the balls fall into the gun from the loader. It'll look like a little black rubber nub and it's primary purpose is the stop the balls from rolling too far forward. Usually, you can stick your finger down the feedneck and feel them. (Please do this with the air off your gun and the gun turned off!)

If it's not there, you can get replacements, or upgrade to what is called a "Timmy detent" which is the same thing, but a bit stiffer.

[SpyderFan]

Originally Posted by vikingshadow

If it's not there, you can get replacements, or upgrade to what is called a "Timmy detent" which is the same thing, but a bit stiffer.

could you give a link to where i could buy a timmy detent. mine broke a while back, and i havent played in a while, and so havent needed to replace it.

[tater_salad]

http://www.sakworldpaintball.com/bobloinbade3.html

There are some.

[VS3 Sniper]

U might also check at ur local pb shop too when I needed some my shop had them.

[vikingshadow]

Originally Posted by SpyderFan

could you give a link to where i could buy a timmy detent. mine broke a while back, and i havent played in a while, and so havent needed to replace it.

Well, I could spend the morning looking for them for you, but I'm lazy - and have to go to my parents to set up their internet. They're FINALLY coming into the 21st century....

As much as I hate just giving the standard "search" answer, I honestly have to be leaving in a few minutes, so here goes....In the sales threads, there is a place that says "Good and Bad Sellers" or something like that - it's stickied, so look at the top. Click that forum and check out all the stores listed there. Then you can search those stores for them.

A faster way might be to go to Froogle.com, or even Google.com and type in Timmy detents and see where it takes you.

[Cyclops]

Ive been having the same problem, the problem ive had is a broken o ring on the striker bolt. Do you feel or see CO2 leaking from anywhere? My CO2 was leaking from where u cock the gun. Check to see if thats ur problem. I still havent solved my problem though cuz i cant get the Striker bolt out it won't go out the back of the marker, I think the striker bolt is to big. If anyone have any suggestions plz help me.