|
|
#1
05-03-2007, 04:09 PM
|
||||
|
||||
Removing the trigger
I can't seem to get the pin that holds the trigger to budge. What are some easy ways to get that pin out? I've tried using a nail and an old allen wrench; results=bent allen wrench, and nail keeps sliding around. BTW this a ACS grip frame (not sure if that matters). Also I've been hitting the pin on the smooth side (I'm pretty sure thats the right side to hit it on).
|
|
#2
05-03-2007, 04:12 PM
|
||||
|
||||
Re: Removing the trigger
the smooth side is what you want to hit. try cutting the tip off the nail.
and if at first you don't succeed, get a bigger hammer
__________________
Quote:
My Feedback! (+9/-0) ಠ_ಠ
|
|
#3
05-03-2007, 04:44 PM
|
||||
|
||||
|
Re: Removing the trigger
It takes hard hits, don't be scared to hit it a little bit harder. also make sure that you find a way to raise the frame so the pin can actually come out.
|
|
#4
05-03-2007, 04:47 PM
|
||||
|
||||
|
Re: Removing the trigger
Yeah, the first time you take it out it really takes a good couple of whacks!
__________________
Almost finished LP Pilot <<XX PILOT OWNERS CLUB # 36 XX>> The Official Manual Thread Spyder Feedback PBN Feedback
|
|
#5
05-03-2007, 04:52 PM
|
||||
|
||||
|
Re: Removing the trigger
Thx guys first I dremeled down the tip of a nail then set the grip frame on a bunched up towel and gave the pin a hard hit and it popped out.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
