|
|
#1
04-28-2007, 05:42 AM
|
||||
|
||||
Anti-chop bolt idea
I know that anti-chop bolts don't seal well due to the fact that they don't have o-rings so would it make any difference if I modified one to have o-rings? These bolts have a really wide inlet port so I'd assume that they'd have a high flow. What does everyone think? Is it worth a shot?
__________________
Quote:
|
|
#2
04-28-2007, 07:50 AM
|
|||
|
|||
Re: Anti-chop bolt idea
Somebody from these boards already tried and the increased friction from the o-rings caused the spring to compress so the bolt wouldn't work correctly.
__________________
My Feedback Pilot ACS, BL Torpedo, BL 0-600 Mini Gauge, 15* CIP assault block, NDZ HP Valve, 06 SP 14" Linear, SPPS Snapdragon Magno-Trigger, X-customs 50g Swix, Dye stickies, Black Macroline, Reloader B2, 68/4500
|
|
#3
04-28-2007, 08:01 AM
|
|||
|
|||
|
Re: Anti-chop bolt idea
the delrin is also to thin and will break if friction doesnt activate the anti chop
__________________
05 Pilot ACS - SPPS Dragon tail trigger, 50 gram switch, CCM feedneck, ACP Bolt, Sticky 3's, Trinity -7 deg. V/A, Rocket Valve, DH Titanium Striker, BL Torp., T board w/ Eyes, Cp Direct Mount On/Off, 275 fps@250 psi VS2 Black to Olive PM6 "All men have fear. The brave ones lay it down and go forward...some unto death but all to victory!" - Kings Guard of Ancient Greece OLD FART CLUB MEMBER My Feedback
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
