halfbacking

[bracer028]

after i saw it, what do i use to sand it?

wouldn't it be very difficult to get the edges and the angles?

[mogar158]

its not to hard after you cut it use a file to neaten it up and also use the file to get angles in the half back

[bracer028]

any way to get a shorter cocking stem?

the aka lightning bolt cocking rod is like 4 inches long and sticks out from the back.

is there a way to cut that cocking rod short enough where you could only cock it with a half back?

what would i use to replace the cocking rod? any ideas? like a metal thumb holder of some sort?



you see that timmy with the cocking nob. is it possible to make it come from the back? where do i get one of those.