|
|
|
|
#1
03-08-2007, 12:10 PM
|
||||
|
||||
? Halo ?
I just got my Halo today, before now I have been using a viewloader revolution.
Anyways, in the instructions, it has the different ball speed settings. The ? that I have is, is it better to set it on the fastest speed even though I may not shoot that fast?? Or will this harm anything?? Thanks
__________________
LP Spyder Pilot 250psi Stiffi Barrel, NDZ Valve, Palmer Stab., Assault Block, Spring Kit, T-Board with Eyes. Feedback: http://www.spyder.tv/forums/showthread.php?t=9477 
|
|
#2
03-08-2007, 12:40 PM
|
||||
|
||||
|
Re: ? Halo ?
highest settings will deplete your batteries and burn your motor out quicker... better off setting it to what you can shoot...
|
|
#3
03-08-2007, 01:33 PM
|
||||
|
||||
|
Re: ? Halo ?
Never mind the possibility of turning it into a paintball blender. Start with the slower settings and experiment with increasing speed.
__________________
Never go Bear hunting without a sandwich...sandwich: someone you can out run or don't mind shooting  Angel 1 Non-SOM Apr 07 Ripper 3 Non-SOM Apr 08 Family Photo My Feedback
|
|
#4
03-08-2007, 07:43 PM
|
||||
|
||||
|
Re: ? Halo ?
doesnt it only turn as fast as you shoot it anyways??
__________________
LP Spyder Pilot 250psi Stiffi Barrel, NDZ Valve, Palmer Stab., Assault Block, Spring Kit, T-Board with Eyes. Feedback: http://www.spyder.tv/forums/showthread.php?t=9477
|
|
#5
03-09-2007, 05:07 PM
|
||||
|
||||
|
Re: ? Halo ?
trust me, make it at the max your GUN can shoot. You might get a luicky fast moment where u can shoot fast for a sec. This is why i have an egg 3 lol. no need for this question if you have an eggy
__________________
Spyder vs2 red body kit barrel tip(red) Shocktech drop, with ndz ultralite on/off Cp regulator (red) trinity reg adapter crossfire 68/45 tank Virtue Board Halo w/v35 board Was it worth it.....? TOTALLY!
|
|
#6
03-09-2007, 05:15 PM
|
||||
|
||||
|
Re: ? Halo ?
Set it for faster than the gun can shoot, if the gun were capped at thirteen bps, I'd set it at around 18, or higher even. Thing is, no loader is entirely consistent, so you make up for it by setting the avg. feed rate to higher than you plan to use.
__________________
05 Imagine Palmer stabilizer Maddman Rocket valve Trinity Front block IPS Sunbear Bolt Dark Horizon titanium striker Green/silver VSC CCI Phantom Red/Black PMR SE
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
