|
|
|
|
#1
10-22-2011, 05:58 AM
|
|||
|
|||
Replacing co2 tank valve
I some how managed to bend the rod of my pin valve on my tank. I am looking to replace it but not sure if I should replace it with a normal valve, a valve with an on/off switch, or one with both an on/off switch and 3000psi gauge. Any advice?
|
|
#2
10-22-2011, 02:19 PM
|
||||
|
||||
|
My advice would be to get a new CO2 tank. They aren't that much more than what you're proposing.
__________________
SOC (+41, -0) | PBN (+12, -0) | New PBN (+20, -0) URT... Ultimate Resource Thread! The [OFFICIAL] Manual Thread! BigRed Photography Quote:
|
|
#3
10-22-2011, 04:37 PM
|
||||
|
||||
|
Re: Replacing co2 tank valve
I was going to say the same thing. Just not cost efficient, IMO, plus you get a whole new tank.
__________________
Pressing on
Never argue with an idiot; they'll drag you down to their level and beat you with experience." ~ Anonymous
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
