|
|
|
|
#1
05-12-2011, 04:46 PM
|
|||
|
|||
Spyder Mr2 FPS Issue
My Mr2 is having some big problems lately. First i was chopping like crazy, replaced the detent. Next I was leaking Co2, replaced the cup seal. Now I'm still leaking Co2 out the barrel, and my FPS is so low, I have an ACP bolt and all my o-rings are good. Any ideas whats the problem?
|
|
#2
05-12-2011, 07:04 PM
|
||||
|
||||
|
Re: Spyder Mr2 FPS Issue
I would look at the valve, are there any nicks or burrs on it? Second I would grab a spring kit, change the main spring and valve spring. find a combination that works well together. this may require some patience. This goes without saying but you should oil and maintain your marker after each match as well, im going to assume you do this.
__________________
General Shawn Wayne Tetz, Commander 187th Gaurds Mechanized Rilfe Division. - Includes the 3rd armored brigade from the 34th Gaurds Armored Division. (APC's and armor as well as support elements) -UCSF Armored Division Commander Armored Units -Deep insertion APC -Killer "B" Battle Tank -Troop Transport APC (almost done) -Gun Truck heavy support unit (In the works) -Order of Lenin (1st) -Skyline Sergeant -YGP Rep! -Sector 4 team feild honor recipiant (UCSF)
|
|
#3
05-13-2011, 01:43 PM
|
|||
|
|||
|
Re: Spyder Mr2 FPS Issue
Well I have a Spring kit on and found a good combo I think. and ya every round i completely clean my gun up. I was shooting around last night and could hit about 40 yards. But I'm still leaking a lotta Co2 which i think is causing me to lose some distance
|
|
#4
05-13-2011, 04:56 PM
|
||||
|
||||
|
Re: Spyder Mr2 FPS Issue
is your valve in the right direction?
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
