|
|
|
|
#1
03-28-2009, 08:42 AM
|
|||
|
|||
What is this part called?
I picked up a cheap victor II and I forget the name of the that plastic part that attached the feed neck to the hopper. I looked up feed neck and found all these parts that you take off the original and put this new one on. I am looking for the cheap plastic thing so friends can play with it. If you know the name woudl you happen to have a link to a store?
Thanks! Jim 
|
|
#2
03-28-2009, 08:49 AM
|
||||
|
||||
|
Re: What is this part called?
feedneck adapter
Get this one in aluminum and it'll never break - http://www.pythonpaintball.com/index...oducts_ id=25
__________________
|
|
#3
03-28-2009, 03:52 PM
|
||||
|
||||
|
Re: What is this part called?
like the plastic elbow? you could go durids route or find a clamping feeneck that will fit your gun, which i beleive is tabs w/ holes, and a clamping feedneck will lower your hopper and then you wont have to worry about any more elbows, and then you get a lower profile. but either way, its up to you.
__________________
Angel g7-blue gloss pure energy 45/5000psi tank w/ ninja reg halo B w/ rip drive
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
