View Single Post
  #1  
Old 02-27-2012, 08:29 AM
spyderon spyderon is offline
New Guy
 
Join Date: Jul 2011
Posts: 19
Default VS3 valve, spring, hammer and bolt in an MR1....

I was doing a tear down and cleaning of a vs3 I just got and started to notice the similarities of the receiver to the MR1. Well, for the hell of it, I installed the VS3 valve, spring, shorty hammer and delrin bolt into my MR1. The bolt needs a modding for a detent grove but other than that it works. The valve on the other hand worked only to about 80% of it's potential as it did not re-cock. I am assuming it is as simple as adding the 3 small relief holes and plugging up the one bigger original hole on the bottom of the receiver? Can anyone verify this or has even done this? I want to be sure before I actually go ahead and look & get xtra vs2/3 parts to actually go thru with this MR1 LP mod.

https://picasaweb.google.com/lh/photo/l1HOADeermKD9c5S3HUcMNMTjNZETYmyPJy0liipFm0?feat=d irectlink

Ron

Last edited by spyderon : 02-28-2012 at 07:28 AM.
Reply With Quote