Thread: MR1 bolt...
View Single Post
  #3  
Old 01-03-2012, 08:47 PM
ElGuapoBond ElGuapoBond is offline
New Guy
 
Join Date: Jan 2011
Posts: 16
Default Re: MR1 bolt...

I pulled out the terminus bolt and put the stock one back in but used DOW33 synthetic lube on the o-rings this time and changed the valve to a 32 Degree high flow with a 32 Degree spring kit, also polished the sear and hammer surface to clean up a lot of creep in the pull and used DOW33 on all the other internals, it does not attack the o-rings like other lubes do over time. Shot an average spread of 272-285 with Spyder Black Label, J&J elite kit out to 14" and a .689 back and used HPA instead of CO2.
Reply With Quote