View Single Post
  #7  
Old 07-25-2011, 07:22 PM
fatkidfrompbaz's Avatar
fatkidfrompbaz fatkidfrompbaz is offline
Ich will mehr, immer mehr, genau wie du, immer mehr
 
Join Date: Dec 2007
Location: Mesa, AZ
Posts: 522
Default Re: I Need Solutions Fast For 2 VS2's

Ok, its been months since i have posted this, but it seems my VS2 has the same problem. I have checked all the O-rings and cup seal and they are all fine. Now there is also a small leak on the hole that holds the valve screw in, even if I add teflon. So what the **** is going on?

Edit: Solution found, apparently I was tightening the screw to much which, in my theory, lifts the valve up and air goes under..
__________________
PBAZ Video of all of Kingman's Spyders as of 2008

VS2:Stock, red body kit, 14" 32* Whisper barrel, Fasta
Victor 2:halfbacked, ESP Frame T- Board, VS2 Barrel, Magna Valve, ND Valve Pin, Drilled VA, Polished Striker, Bandit 2 O-ring Delrin Bolt, Custom Trigger, Rex Expansion Chamber, ND Feedneck, T-board

Last edited by fatkidfrompbaz : 07-25-2011 at 07:48 PM.
Reply With Quote